The Commodore 64 Reloaded Power Plate for the 64 Breadbin case.

Anyone with an "Individual Computers" 64 Reloaded board, that's put it into an original style breadbin case knows about the gaping hole in the side of the case where the old DIN connector was replaced by the much smaller barrel power connector.

This 3D printed piece that will insert over the barrel connector on the 64 Reloaded board. It fits snugly around the barrel connector, and has a flange that reaches over to the rear-right side of the board. Both holes in the 64 Reloaded board are accommodated in the mounting flange.  Although the standard 64c power plate will work, this power plate is slightly larger and wider to completely cover the original round hole where the power plug DIN connector used to be. 

The plate of the flange is 3mm thick, however the screw mount is recessed at that point to allow you to use your factory screws, by adding only 1mm of thickness at that point. 

The bracket fits snugly around the board mounted barrel connector, and does not move when installed. 

Close up that ugly hole in the side of your 64 Reloaded Commodore Breadbin Case with this "64c Reloaded Power Plate"