This original COREi64.com designed case was created to house the raspberry pi that works in conjunction with the TIPI case developed by Jedimatt over at Atariage.

This Raspberry Pi 3 compatible case has a display window incorporated into the cover plate to accommodate the Adafruit display (PiOLED) being inserted directly onto the GPIO header.

This product comes as a 3 part set, lid, bottom and stand. As with all my cases, heatsets are embedded into the plastic and black oxide screws are used to hold it all together.  The lid of this case has two embedded "LIGHT PIPES" which route light from the surface mounted LEDs to the lid.  There is some light bleed between the two pipes, but the light is routed to the surface of the lid.  This is accomplished using translucent PLA filament as a "light pipe".

Two screws hold the Raspberry Pi 3 onto the base, four screws hold the lid to the base, and two screws hold the case to the stand. Cables to power the raspberry pi are conveniently located at the bottom of the case when viewed mounted on the stand, and a cable channel is built into the base to route the GPIO cables from the pi to the TIPI. These cables route through the back to provide a clean look.

Take note that the Raspberry Pi and PiOLED display is not included in this item.  This item is for the stand, case and lid only.