NEW Ultimate 64 Light Strip Mount for the 64c

This is a new mounting system for the optional RGB controllable 24 LED light strip for inside the 64c case. This mounting design attaches to the back lip of the keyboard through existing factory holes using black oxide screws and heatsets. It is a two piece system with a left and right component. The area around the userport breakout is left open to allow for my breakout board or cabling. The LED strip spans that small gap.

The beauty of this installation is that if you remove the keyboard, the whole LED mount comes with it. It is compatible with my regular keyboard mounts as well as the left side userport mount that allows for access to the user port through the left side of the machine.

We also have 24 LED strips for the Ultimate 64. These are neatly soldered and both conductive ends are protected with heatshrink. The cable is 40cm long, and +5v is identified on every cable to ensure it is properly connected. The connector is wired to match our breakout board as follows: (+5V, CLKI, SDI, GND). This is the same pinout as found on the new v1.4 boards by Gideon Zweijtzer. (Pin: 1 2 3 4 | GND DAT CLK 5V) Care must be taken to ensure the LED strip is plugged in the proper orientation otherwise damage to your board will occur.



The breakout board if you need one can be found here: CLICK HERE



Note that the light strip, is not included with the mount, you need to obtain one, or purchase it from us separately.

Ultimate 64 Light Strip mount for 64c case

  • Product Code: U64LSMNT
  • Availability: In Stock
  • $16.95

  • Ex Tax: $16.95

Available Options


Available Filament Colors

Scroll through the available colors.

Natural Translucent
Purple
Grey
Orange
Pink
Pine Green
Magenta
Brown (Dark Chocolate)
Black
Green (Dark Translucent)
Gold
Peak Green
Blue (Dark Translucent)
Red
Light Blue
Yellow
Glow in the Dark Blue
White
Silver